This plugin adds a few $
commands for listing files and running G-code from a SD Card:
$FM
Mount card.
$F
List files on the card recursively.
$F=<filename>
Run g-code in file. If the file ends with M2
or rewind mode is active then it will be "rewound" and a cycle start command will start it again.
$FR
Enable rewind mode for next file to be run.
$F<=<filename>
Dump file content to output stream.
$FD=<filename>
Delete file.
Dependencies:
NOTE: some drivers uses ports of FatFS provided by the MCU supplier.
Experimental ymodem upload support has been added as an option from build 20210422. Enable by setting SDCARD_ENABLE
to 2
in my_machine.h.
This requires a compatible sender as the initial C
used to start the transfer will not be sent by the controller. Transfer is initiated by the sender by sending the first packet.
2021-04-23