BMI Air Mouse

Brief

"You can turn anything into an air mouse if you're brave enough"

— Piper, a.k.a. Pez

Naturally, the quote above applies to Flipper as well.

The app allows you to turn your Flipper into a USB or Bluetooth air mouse (you do need an extra module, see the Hardware section below)...

Using it is really simple:

Connect the Flipper via a USB cable and pick USB, or pick Bluetooth and pair it with your PC;
Hold the Flipper in your hand with the buttons pointing towards the screen;
Wave your Flipper like you don't care to move the cursor;
Up button for Left mouse click;
Down button for Right mouse click;
Center button for Middle mouse click;
Left and Right buttons for scrolling;
Use calibration menu option if you notice significant drift (place your Flipper onto a level surface, make sure it doesn't move, run this option, wait 2 seconds, done).

See early prototype in action.

Clone this repository with git clone --recurse-submodules to include the driver implementations.
Build the project using ufbt

The custom module is using Bosch BMI160 accelerometer/gyroscope chip connected via I2C.

Note: in fact, some other IMU chips are also supported. It's detected via the first found I2C Address.

Take a look into the schematic folder for Gerber, BOM and CPL files, so you can order directly from JLCPCB.

Original idea:

Expectation:

Reality:

The code is based on the original Bosch driver and an orientation tracking implementation from the Google Cardboard project

TL;DR: Use the code however you want, give credit where it's due, no warranty of any kind is provided.