This directory contains source files for the Komi-Zyrian language morphology and dictionary. The data and implementation are licenced under __GNU GPL__ licence also detailed in the LICENCE file of this directory. The authors named in the AUTHORS file are available to grant other licencing choices.
Installation and compilation, and a short note on usage, is documented in the file INSTALL.
Documentation is scattered around on the Giellatekno and Divvun pages, e.g.:
- http://giellatekno.uit.no/kpvdoc/index.html
- http://giellatekno.uit.no/doc/tools/docu-kpv-manual.html
- http://divvun.no/doc/index.html
In order to compile and use Komi-Zyrian language morphology and dictionaries, you need:
- Xerox Finite-State Morphology tools, or
- Helsinki Finite-State Technology library and tools, version 3.8 or newer, or
- Foma finite-state tool
Optionally:
- VislCG3 Constraint Grammar tools
The Komi-Zyrian language sources can be acquired using giella SVN repository, from the language specific directory, after the core has been downloaded and initial setup has been performed.
INSTALL describes the GNU build system in detail, but for most users the usual:
./configure make (as root) make install
should result in a local installation and:
(as root) make uninstall
in its uninstallation.
If you would rather install in e.g. your home directory (or aren't the system administrator), you can tell ./configure:
./configure --prefix=$HOME
If you are checking out the development versions from SVN you must first create and install the necessary autotools files from the host system, and check that your environment is correctly set up. This is done by doing:
./autogen.sh
It is common practice to keep generated files out of version control.
If you want to keep the source code tree clean, a VPATH build is the solution. The idea is to create a build dir somewhere outside of the source code tree, and call configure from there. Here is one VPATH variant of the standard procedure:
mkdir build && cd build ../configure make (as root) make install
This will keep all the generated files within the build/ dir, and keep the src/ dir (mostly) free of generated files. If you are building from the development version in SVN, you must run the ./autogen.sh script BEFORE you take the steps above.
For further installation instruction refer to file INSTALL, which contains
the standard installation instructions for GNU autoconf based software.