A very simple DIY euro rack module (16HP, Intellijel 1U format) to interact with the sun. Inspired by many other manufacturers. Very straightforward build, with just two parts and a 3D print ;)
Possible future variations
- 3U version
- 1U version with smaller cells
If you're having any problems / difficulties, please let me know: Instagram // Discord
Disclaimer!: I'm not an electrical engineer, I'm just doing this for fun. Please proceed at your own risk :)
-
The 3D printed panel. Important: Print this with the indent for the panel TOWARDS the build plate, with supports.
-
1x Thonkiconn + washer, I'm using a Befaco Bananut for +1 style point.
-
Depending on your exact type of solar cell, you might need some additional cable. The linked ones work as is.
-
Soldering iron.
-
Double sided tape to fix the solar cell in place.
- Print the panel.
- Remove the supports. Use a screwdriver or box cutter if needed. Watch your fingers!
- Put some double sided tape in the indent, make sure to leave the holes for the cables free.
- Feed the cables through and fix the solar cell in place.
- Put in the Thonkiconn jack and fix it with the nut.
- Shorten the wires and solder them to the jack. "-" goes to GND, "+" goes to the tip.
- Put it in your 1U row and enjoy the sun ;)
I hope this was a fun project and you got through with ease. If you're having difficulties at any point, please let me know. I'd also love to see your creations! Tag me on Instagram or send me a photo to add here. Check out my music on YouTube or Instagram. You can Buy me a coffee if you've found my work helpful :)