How to join:
If device in FN(factory new) state:
- Press and hold button (1) for 2-3 seconds, until device start flashing led
- Wait, in case of successfull join, device will flash led 5 times
- If join failed, device will flash led 3 times
If device in a network:
- Hold button (1) for 10 seconds, this will reset device to FN(factory new) status
- Go to step 1 for FN device
Hardware
2AAA version
- Gerber, BOM, Scheme 2AAA
CR2 version
- Gerber, BOM, Scheme CR2
- Attention! Do not use CR2032 and CR2450 with a motion sensor (AM312 / BS312), as at low battery voltage (<3v) false alarms occur.
Firmwares
- Downalod from github releases
Thanks for the help
- firmware github diyruz by @anonymass
- hardware and testing by @ring04
- telegram channel Zigdev