eggfly / T-Display-S3-AMOLED

An upgraded version of T-Display-S3. It has a high-resolution color screen and more configurable GPIO ports. Enrich your needs.

🌟T-Display-S3- AMOLED🌟

News

This repository only supports the non-touch version of T-Display-S3-AMOLED. Touch version is not supported. For the touch version, please go to LilyGo-AMOLED-Series

This repository was created by @mmMicky earlier, LilyGo-AMOLED-Series also supports the non-touch version. For the non-touch version, it can be used in two Choose between warehouses

Description

T-Display-S3-AMOLED is an ESP32-S3 development board. Equipped with a new AMOLED high-resolution color LCD screen and 2 programmable keys. Communication adopts SPI or QSPI interface. Keep the same layout design as T-Display. You can directly use ESP32S3 for USB communication or programming.

Pinout

Where to buy

T-Display-S3-AMOLED is available from: LILYGO, Amazon and Aliexpress.

Quick Start

The board uses USB as the JTAG upload port. When printing serial port information on USB, CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.

• Press and hold the BOOT button when the power is off, the button is located behind the RST button.
• When the USB is connected, first press and hold the BOOT button, then click reset and then release the BOOT button

Arduino

1. In Arduino Preferences, on the Settings tab, enter the https://raw.githubusercontent.com/espressif/arduino-esp32/gh-pages/package_esp32_index.json URL in the Additional boards manager URLs input box.
2. Click OK and the software will install.
3. Search for ESP32 in Tools → Board Manager and install ESP32-Arduino SDK (version 2.0.3 or above)
4. Copy everything from this repository lib folder to Arduino library folder (e.g. C:\Users\YourName\Documents\Arduino\libraries)
5. Select the correct settings in the Tools menu as shown below.

PlatformIO

1. PlatformIO plug-in installation: click on the extension on the left column → search platformIO → install the first plug-in
2. Click Platforms → Embedded → search Espressif 32 in the input box → select the corresponding firmware installation

ESP-IDF

The installation method varies depending on the system, refer to the official manual for installation.

Q&A

1. There are two ways to drive the screen. One is the traditional SPI (CS, MOSI, SCLK, DC) interface. One is to use the QSPI method (CS, SCLK, D0, D1, D2, D3). The QSPI method can increase the driving speed by four times compared with the SPI. to fit the larger screen.

• Here you can choose to use traditional SPI or new QSPI mode.
• To use the SPI interface, you need to set LCD_USB_QSPI_DREVER to 0 in pins_config.h

FAQ

1. The board uses USB as the JTAG upload port. When printing serial port information on USB_CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.

   1. Connect the board via the USB cable
   2. Press and hold the BOOT button , While still pressing the BOOT button, press RST
   3. Release the RST
   4. Release the BOOT button
   5. Upload sketch

2. If the above is invalid, burn the binary file to check whether the hardware is normal

   • Video