3d-models contains OpenSCAD files that survived after HDD crash:
- aaa-hor.scad is enclosure for PCB and 4 AAA recharcheable batteries
- m1.scad is an enclosure for 9g servo. Please note:
- servo should be modified to enable 360 degree rotation
- 3d printer should be paused before printing the roof, to embed servo itself
Software structure is inherited from https://github.com/Spritetm, see https://github.com/dmisol/wifi4lego/wiki
ToDO: actual manual will be added
sch and pcb files were lost during HDD crash (with both home and git folders)
ESP-03 is connected as follows:
- GND -> GPIO15, GND
- 3.3V -> CH_PD, VCC
- PWM0 -> GPIO12
- PWM1 -> GPIO13
- PWM2 -> GPIO14
- RX,TX -> URXD,UTXD (for flashing)
- FLASH -> GPIO0 (for flashing)
Will also try to fetch Gerber files from Seeed, if they are keeping archive of orders