Power the fire control bell by using a raspberry pi with GPIO and relays.
On one of 8 pins of the gpio interface:
- 1 pulse every second
- 1 pulse every 5 seconds
- 1 pulse every 10 seconds
- every 15 seconds three pulses a second apart
- every 20 seconds three pulses a second apart
- every 30 seconds three pulses a second apart
- every 40 seconds three pulses a second apart
- every 60 seconds three pulses a second apart
-
ssh into the raspi ssh pi@ password: raspberry pi@:~ $
-
Clone the repo
-
Go into the folder and build and install
cd firecontrol make build install
-
This should have installed the firecontrol command. If you run it, it will start.
$ firecontrol