This is a copy of the last official release of the ftape driver (version 4.04a) by Claus-Justus Heine et al, with some of my own tweaks for getting it to compile and run on CentOS 3.5.
DISCLAIMER: I am not a kernel developer, and I barely stumbled through getting this driver to compile and make it work the way I needed. In case anyone wants to learn from my mistakes (and in the spirit of GPL) I'm making this code and my changes available, but don't judge me for the horrible jury-rigging I did to make it work.
Ftape was a driver that allowed Linux to read data from "floppy tape" drives, i.e. tape drives that would connect to the floppy controller (FDC) directly on the motherboard, such as the Colorado Jumbo 250, the Ditto Max, etc. It also supported numerous external tape drives that connected to the parallel port of the PC, such as the Trakker, Iomega Ditto 2GB, etc.
This driver used to be included in the Linux kernel, until it was removed in 2006, as of kernel version 2.6.20.
However, that's not the whole story:
- The last version of the driver that was included in the kernel, right up until it was removed, was version 3.04.
- BUT, the author continued to develop the driver independently of kernel releases. In fact, the last known version of the driver was 4.04a.
- Unfortunately the author continued to develop the driver on an older version of the kernel (probably 2.2.x), which made it somewhat incompatible with later kernel versions.
This is the oldest distro I could find (installed from ISO images) that boots nicely (graphically, with USB support, etc) on my old PC workstation, and has a kernel version of 2.4.21, which brings it just within reach of a horribly amateur kernel hacker to compile ftape onto.
With a default install of CentOS 3.5 (all defaults except "software development" and "kernel development" packages selected), I was able to compile ftape, load it, and use it to communicate with my tape drives!
- Install CentOS from the aforementioned ISO images, making sure to install the "kernel development" package.
- Get this repo somewhere into your home directory on your new CentOS install.
- Make any necessary modifications to MCONFIG. Specifically, you might need to modify the LINUX_LOCATION variable, to point to the source tree of your linux kernel, and the KERNELRELEASE variable to be the exact name of your kernel release.
- Run
make!
The build process might complain about the .config file not being present in your kernel source tree. To fix this, you can copy your current config... from your /boot partition and name it .config in the root of the kernel tree.
When (if) the build process finishes, it should make several kernel modules (.o files) in the modules subfolder. These are modules that are loadable using insmod or modprobe. Also in the modules folder are a few convenient scripts for inserting the modules in the correct order, for different types of drives, and containing some example parameters that the modules accept. There's actually no need to run make install (which copies the modules into your actual /lib/modules/... directory), I just prefer to load the modules directly from the build directory on demand.
There is also scripts/MAKEDEV.ftape that you should run to create the necessary device nodes under /dev/.
Once all of this is done, and the kernel modules get loaded without errors, you can interact with the device files, e.g. /dev/nqft0, /dev/rawqft0 and so on.