Breakout board for the STM32G071GBU6
I've built one of these and measured:
- (unpowered) no shorts
- (unpowered) diode between I/O and ground
- (powered) 3V3 output is fine
Reset was not tested.
I didn't have the exact switch (KMR2) but one with an extra ground tab (KMR2xxG) but you that's not a problem - the ground tab doesn't touch antything.
Flashing a binary with st-flash worked too.
The breakout board was not tested with external circuitry yet.
A very simple breakout board for the STM32G071GBU6:
Reset circuitry (pull-up, cap, push button to GND) can be connected to PF2/NRST by closing solder jumper JP1.