TM-V71 and TM-D710(G) Kenwood - PC RIG control commands
Reverse engineered RIG control commands for the Kenwood TM-V71 and TM-D710(G).
Thanks to: LA8OKA, W6GPS, WM8S and N1LKS for helping.
Based on rev.11 02 april 2009
Contributing
Please report any errors or new information to the issue tracker.
Additional information
Available control commands for the display unit
(Firmware V1.04 TM-D710Gx, Firmware V2.15 TM-D710x)
These commands work with the display unit on the TM-D710 (and the TM-V71 when using the RC-D710 accessory).
- AE Display serial number (This will display gibberish)
- BE Enable/disable BCON - TMD710G (When APRS is enabled)
- BL Backlight status
- CS Callsign
- GP Internal GPS - TM-D710G
- GT Internal GPS Returns N if internal GPS is not on
- ID Radio Model
- RT Time
- SR Reset
- TC TNC control mode
- TN TNC status
- TS TNC control mode 2
- TY Display Type
- 0M PROGRAM Enters MCP programming mode
Available control commands for the main unit
(Firmware V1.04 TM-D710Gx, Firmware V2.12 TM-D710x)
- AE Radio serial number
- AS Reverse
- BC PTT and CTRL Band
- BT Burst tone
- BY Squelch open/closed
- CC Call channel
- CD Toggle between memory name and channel number
- DL Dual Band Mode/Single Band Mode
- DM DTMF memory
- DT DTMF
- DW Emulates the Microphone Down Key
- FO VFO channel
- FV Firmware version
- ID Radio Model
- LK Lock
- ME Memory channel, frequency, offset etc
- MN Memory name
- MR Memory channel
- MS Power on message
- MU Menu
- PC Output power
- PV Programmable VFO
- RX Receive
- SQ Squelch status
- SR Reset
- SS S-meter squelch
- TT Transmit tone
- TX Transmit
- TY Radio Type
- UP Emulates the Microphone Up Key
- VM Memory/VFO
- 0M PROGRAM Enters MCP programming mode
- 0G KENWOOD Enters service mode