Prints of the STLs, and also mirrord prints of hebel.stl and spange.stl.
- A Bit of 4mm axle
- two collets to stop the axle from falling out. Prototype uses FischerTechnik clip-on collets.
- M3 all-thread
- four DIN934 M3 nuts
- one M3 standoff to adjust the pushrod
- two M3 screws
This is an old design I made back in 2017, it is also on YouMagine
Worked fine so far, for my light duty and smd rework tasks.
Images are stored using LFS