Arduino/zum compatible Open FPGA electronic board. Synthesize hardware easily, using only open source tools
- FPGA development board (iCE40HX1K-TQ144 from lattice)
- Open hardware
- Compatible with the opensource icestorm toolchain
- Arduino like board: similar pinout than Arduino one / BQ zum.
- You can Reuse most of available shields
- Control your robots / printbots from an FPGA
- 12 MHZ MEMS oscillator
- ON/OFF switch (turn off your mobile robot easily)
- Input power voltage: 6 - 17v
- Max input current: 3A (Perfect for powering your robots)
- 20 Input/output 5v pins
- 8 Input/Output 3.3V pins
- USB micro-B connector for programming the FPGA from the PC (same than zum board)
- FTDI 2232H USB device allows FPGA programming and UART interface to a PC
- Reset pushbutton
- 8 general purpose leds (user leds)
- 2 general purpose pushbuttons
- 4 analogue inputs though I2C bus
The project documentation is located in the wiki
- Eladio Delgado Mingorance
- María Delgado Mingorance
- Juan González
- Design derived from the zum core board by BQ
- Design derived from the Icestick by Lattice
- Icestorm project, by Clifford Wolf and Mathias Lasser
Licensed under Creative Commons Attribution-ShareAlike 4.0 International License