Klipper Firmware
WARNING!
This repo is for my own personal use so that I have a backup of my Klipper config. Copying this config as-is to use as your own could worst case cause damage to your printer. If you are using this as a base to define your own configuration, make sure that you also read the official Klipper examples to understand what the settings mean, and more importantly what they need to be set for your particular printer.
Use at your own risk!
Klipper config for CR-10S printer with the following modifications that impact firmware configuration:
- SKR 1.3 board
- TMC2209 drivers
- BondTech BMG Extruder
- Mosquito Magnum hotend (including Mosquito high temperature sensor and heater cartridge)
- 3DFused x, y and z linear rail kits
- 3DFused z-braces
- EZABL Pro
- 24V PSU
- Moons MS17HA6P4200-06 0.9 deg steppers on X/Y, and Mons MS17HD6P4200-29 1.8 deg steppers on Z/Z1
Includes the following macros
- START_PRINT : to be called at start of each print. Homes, loads the bed mesh profile, then calls PRIME_LINE
- PRIME_LINE : called by START_PRINT to draw a couple of primes before the print to prime the nozzle
- END_PRINT : to be called at the end of each print. Turns off heaters and motors
- M600 : Load filament macro (calls PAUSE_MACRO then UNLOAD macros)
- PAUSE_MACRO : Saves the gcode state, calls PAUSE, then PARK_MACRO
- PARK_MACRO : Moves the nozzle to a safe location
- UNLOAD : Retracts the filament
- PURGE : Purges 45mm of filament
- LOAD_FILAMENT : Loads filament
- RESUME_MACRO : Loads the gcode state that was saved during PAUSE_MACRO, then calls RESIME
- G29 : Automatic bed levelling
Other points to note: TODO