armyofevilrobots / tinkerbelle

3D Powder printer firmware

 _______ __         __                __           __ __        
|_     _|__|.-----.|  |--.-----.----.|  |--.-----.|  |  |.-----.
  |   | |  ||     ||    <|  -__|   _||  _  |  -__||  |  ||  -__|
  |___| |__||__|__||__|__|_____|__|  |_____|_____||__|__||_____|

[TOC]

---

Tinkerbelle: Arduino firmware for powder printers

Disclaimer

This is a work in progress. Don't expect it to work, boot, or even run without damaging your hardware.

Requirements:

• Atmega1280 or better
• Inkshield from http://nicholasclewis.com/projects/inkshield/
• Suitable motor driver board (to be released separately)
• Powder printer like tinkerbelle (TBA: Thingiverse or similar)
• Patience