My ESPHome configurations
An ESP32 camera.
A simple PIR sensor with LED indicator. Indicator goes high brightness to show the actual sensor is detecting movement and mid-brightness for a while until it decides the room is clear.
Using a 4-channel MOSFET-output board, control three white analog LED strips (izquierda, central, derecha) hidden behind a headboard, and controlled using four rotary encoders. Central light can be fully controlled from two encoders (both sides of the bed), and pressing both encoders on any side switches off all three lights (good night!). Includes pressure-sensor presence detection.
Same as the above, but connects via wireguard, no presence detection, and controls act in a different order.
Full color moon lamp, has a wake-up (despertar) routine.
Awning controller with an hall-sensor anemometer.
Simple ESP01-relay based single valve irrigation controller.
Two-valve plus transformer irrigation controller with a pressure sensor. If there is no water pressure, time doesn't count and the system waits until there actually is water available.
Motorized rolling shutter controller (time-based cover) with a pre-set closing position other than fully-closed, and a 4-button panel.
Single analog white strip lamp with wake-up routine and ambient sensors (temperature, humidity). Uses OLED display to show ambient conditions as well as lamp status and time.
Sample configuration for a 4-relay board. I'm not using this configuration as-is, but it's the generic one I based my toldo1 and riego2 configs.
A configuration based on the previous one, with a MCP23017 taking care of the relay outputs as well as AC inputs.