Wire
Admin Panel for Laravel Applications
Install The package By running
composer require rapkit/wire
Once the package is installed you need to publish it by running the following command:
php artisan vendor:publish --provider="Rapkit\Wire\WireServiceProvider"
You will also need to register a service provider that has been published to modify some of the functionalities of Wire.
Either register it in config/app.php
App\Providers\WireServiceProvider::class,
If you register it inside config/app.php make sure to clear config cache with php artisan config:clear
or inside register method of AppServiceProvider:
$this->app->register(WireServiceProvider::class);
To create an identifier run:
php artisan wire:identifier User
An identifier is where you place your Model parameter to be used within wire.
User, in this case, is your Model name.
Identifiers will be located in App\Wire\Identifiers
If your model is located in an unusall Path,
you can configure that in config\wire.php by updating:
'model_path' => 'App\\',
When an identifier was created, Wire will automatically cache it to show in the menu, but if you would like to specifically cache each identifier that you would like to show in the menu, you can run:
php artisan identifier:cache --User
If you run php artisan identifier:cache with no Identifier name, then it will cache all of the identifiers.
You can remove identifier list with php artisan cache:clear command of laravel.
Fields for given identifier will be loaded when it's created, if there is no such model or table at time of creation, you can run php artisan identifier:load User, but if the table content is changed after the creation you can run
php artisan identifier:load User --f
Refer to https://github.com/rapkit/wire/wiki/Fields for more information about fields