adsb.fi feed client
- These scripts aid in setting up your current ADS-B receiver to feed adsb.fi.
- This will not disrupt any existing feed clients already present.
- When setting up new feeders, a decoder such as readsb must be installed separately.
1: Find antenna coordinates and elevation
https://www.freemaptools.com/elevation-finder.htm
2: Install the feed client
curl -L -o /tmp/feed.sh https://adsb.fi/feed.sh
sudo bash /tmp/feed.sh
3: Use netstat to check that your feed is working
netstat -t -n | grep -E '30004|31090'
Expected Output:
tcp 0 182 localhost:43530 116.202.4.168:31090 ESTABLISHED
tcp 0 410 localhost:47332 116.202.4.168:30004 ESTABLISHED
4: Optional: Install local interface for your data
The interface will be available at http://192.168.X.XX/adsbfi
Replace the IP address with the address of your Raspberry Pi.
Install / Update:
sudo bash /usr/local/share/adsbfi/git/install-or-update-interface.sh
Remove:
sudo bash /usr/local/share/tar1090/uninstall.sh adsbfi
Update the feed client without reconfiguring
curl -L -o /tmp/update.sh https://raw.githubusercontent.com/adsbfi/adsb-fi-scripts/master/update.sh
sudo bash /tmp/update.sh
If you encounter issues, please do a reboot and then supply these logs on Discord (last 20 lines for each is sufficient):
sudo journalctl -u adsbfi-feed --no-pager
sudo journalctl -u adsbfi-mlat --no-pager
Display the configuration
cat /etc/default/adsbfi
Changing the configuration
This is the same as the initial installation. If the client is up to date it should not take as long as the original installation, otherwise this will also update the client which will take a moment.
curl -L -o /tmp/feed.sh https://raw.githubusercontent.com/adsbfi/adsb-fi-scripts/master/install.sh
sudo bash /tmp/feed.sh
Disable / Enable adsb.fi MLAT-results in your main decoder interface (readsb / dump1090-fa)
This is enabled by default. You probably don't need to change that.
- Disable:
sudo sed --follow-symlinks -i -e 's/RESULTS=.*/RESULTS=""/' /etc/default/adsbfi
sudo systemctl restart adsbfi-mlat
- Enable:
sudo sed --follow-symlinks -i -e 's/RESULTS=.*/RESULTS="--results beast,connect,127.0.0.1:30104"/' /etc/default/adsbfi
sudo systemctl restart adsbfi-mlat
Restart the feed client
sudo systemctl restart adsbfi-feed
sudo systemctl restart adsbfi-mlat
Show status
sudo systemctl status adsbfi-feed
sudo systemctl status adsbfi-mlat
Removal / disabling the services
sudo bash /usr/local/share/adsbfi/uninstall.sh
If the above doesn't work, you can just disable the services and the scripts won't run anymore:
sudo systemctl disable --now adsbfi-feed
sudo systemctl disable --now adsbfi-mlat