HP-ILO-Fan-Control

Allows a Simple Fan Curve to be set using the custom ROM made by u/phoenixdev on Reddit. (linked below) This repo contains all of the required files! :)

All you need to run is the commands below.

Currently, the scripts are only for Linux!

~~ESXi Support is in the works!~~ Thanks to @thomaswilbur For making the ESXI verstion of the script! - see EXSI readme

STEPS:

Switch ILO into maintainance mode, then reboot. (On the DL360 G8, this is located near the backplane connectors to the motherboard.)
Download the install.sh script and run it. This will download all required files and move them, installs the autofan.service, and downloads the correct autofan.sh based on your input ready to be edited. If you are an advanced user, you can install everything sperately. (Download using wget https://raw.githubusercontent.com/That-Guy-Jack/HP-ILO-Fan-Control/main/Install.sh)
Run the prep.sh in the ilo_250 folder. If this errors it may be beacuse the ILO isnt it maintainance mode. (You may need to run this script as root.)

./flash_ilo4 --direct

(When flashing the fans spin up to 100%, so be prepared)

Once the flash has completed, shut down your system and unplug it. Make sure to switch ILO back out of maintainance mode.
Configure autofan.sh in the / directory. Replace your password, your username, and your ILO ip with the correct info. Once done, save and exit.
Run systemctl daemon-reload and systemctl start autofan to activate the service.
Create a crontab command to start the systemd service on startup: @reboot systemctl start autofan.
Enjoy silence! :) And if thats toO fast or slow, edit the autofan.sh to your needs.

Tested Servers:

1U Servers:

DL360p Gen8

2U Servers:

DL380p Gen8 DL380p Gen9 DL80 Gen9 - Tested by @rootless4real

Notes

I recommend especially for the DL360 to add a small 40mm fan to the RAID controller to keep it cool.
If you have the fan script working on a different server than what's listed in the tested server section, create a issue and I'll add it.

To-do

Create a Script to Install and Create fan control scripts
Allow easier input of ILO pramaters
Make ESXI friendly version - Script now Existis and works just needs automation
Add info about the security switch
Allow users to input ILO paramaters when using install.sh
Make the install.sh script have fun colours :D

Links and other stuff

Original Reddit post: https://www.reddit.com/r/homelab/comments/hix44v/silence_of_the_fans_pt_2_hp_ilo_4_273_now_with/

TannerFilip / HP-ILO-Fan-Control