This is a basic example of GPIO control on the Rasperry Pi using Python
We use the GPIO board pin mapping and we also need few LEDs on two sets of GPIO pin:
Set A: 3,5,7,8,10,11,12,13,15 (pin number) Set B: 16.18,19,21,22,23,24,26 (pin number)
In this example, the LEDs on two sets will be switched between on and off after one sec. If set A is on then set B is off and vice versa.
All you need to do is :
- clone this repo locally and cd into the folder.
- connect some LEDs to two pin sets
- add the resin remote repo with
git remote add resin git@git.resin.io:myGithubName/myResinAppName.git, with the correct github and app name, or just copy if from the top right hand corner of your device dashboard on resin.io. - now just
git push resin masterwait a minute or so for the code to upload and start. - enjoy the all the LED goodness...