SalomePlatform / hexablock

HexaBlock module facilitates the creation of hexahedral meshes using the block method in SALOME

**********************
About SALOME HexaBlock
**********************

SALOME HexaBlock module is designed to help users to build hexahedral meshes 
with the block method, but without modifying of the geometry.

For more information please visit the SALOME platform web site:

  <https://www.salome-platform.org/>

=======
License
=======

SALOME platform is distributed under the GNU Lesser General Public License.
See COPYING file for more details.

============
Installation
============

--------------
Pre-requisites
--------------

SALOME platform relies on a set of third-party softwares; some of them are needed
at build time only, while other ones are needed in runtime also.

For more information about the pre-requisites please visit SALOME platform web
site:

* Check Release Notes and Software Requirements of the latest SALOME release at

  <https://www.salome-platform.org/?page_id=15/>

Note: SALOME HexaBlock module needs SALOME KERNEL, SALOME GUI and SALOME
Geometry as pre-requisites.

------------------
Basic Installation
------------------

The build procedure of the SALOME platform is implemented with CMake.
In order to build the module you have to do the following actions: 

1. Set up environment for pre-requisites (see "Pre-requisites" section above).

2. Create a build directory:

   % mkdir HEXABLOCK_BUILD

3. Configure the build procedure:

   % cd HEXABLOCK_BUILD
   % cmake -DCMAKE_BUILD_TYPE=<mode> -DCMAKE_INSTALL_PREFIX=<installation_directory> <path_to_src_dir>

   where
   - <mode> is either Release or Debug (default: Release);
   - <installation_directory> is a destination folder to install SALOME HexaBlock
      module (default: /usr); 
   - <path_to_src_dir> is a path to the SALOME HexaBlock sources directory.

   Note: by default (if CMAKE_INSTALL_PREFIX option is not given), SALOME HexaBlock
   module will be configured for installation to the /usr directory that requires
   root permissions to complete the installation.

4. Build and install:

   % make
   % make install

   This will install SALOME HexaBlock module to the <installation_directory>
   specified to cmake command on the previous step.

-------------------
Custom installation
-------------------

SALOME HexaBlock module supports a set of advanced configuration options;
for more details learn CMakeLists.txt file in the root source directory.

You can also use other options of cmake command to customize your installation.
Learn more about available options by typing

   % cmake --help

=============
Documentation
=============

The directory doc contains additional documentation file of SALOME HexaBlock
module.

===============
Troubleshooting
===============

Please, send a mail to [e-mail].