-
Run the following command to install conky:
sudo apt install conky-all
-
Create the config file:
conky -C > ~/Documents/conky.config
-
Create the conky folder in the home directory:
mkdir ~/.config/conky
-
Replace the content of the created config file with the content from this file "You can use any text editor to copy the content"
-
Copy the file to the conky folder in your home directory:
cp -v ~/Documents/conky.config ~/.config/conky
-
Adjust the hardware configuration according to your settings
-
Network adapter parameter "Replace enp6s0 with the name of your network adapter". Run the below command to find the name of your network adapter:
sudo ifconfig
-
Processor "Replace AMD Ryzen 5 @ 3.60GHz with the name of your processor"
-
The number of your CPU cores, run the following command to find out how many cores is your CPU:
nproc
-
Temp sensor. You can run this command to find out how many sensors you have:
ls /sys/class/hwmon
- Then this command to find the name of each sensor "Make sure to change the number after hwmon to check all your sensors":
sudo cat /sys/class/hwmon/hwmon4/name
-
-
Create an auto start item for conky to load once system is started
