This program can setup the modules E32 and E36 and probably others also.
To program you have to set the M0 and M1 to 1 In combination with the module E15-USB-tl this is easly done with jumpers, remove the jumpers M0 and M1 then you can program the device.
#Compile: make
#To Run use: ./program-rf-ttl -d /dev/ttyUSB0 -a7 -s7 -o
#Options you can use:
- -d serial port
- -o Write permanent
- -f <0-1> FEC
- -w Waiting time
- -c Communication channel 0-31
- -p <0-3> Output power 0-3 (0=30dBm - 3=21dBm)
- -a <0-7> Air speed 0=1Kbps(default)
-
1=2Kbps -
2=5Kbps -
3=8Kbps -
4=10Kbps -
5=15Kbps -
6=20Kbps -
7=25Kbps - -s <0-7> uart speed
-
0=1200bps -
1=2400bps -
2=4800bps -
3=9600bps -
4=19200bps -
5=38400bps -
6=57600bps -
7=115200bps