Pull the image from Dockerhub.
docker pull thomasleister/peervpn
The default ENTRYPOINT will generate a configuration file for PeerVPN
(unless one exists already) based on supplied environment variables and
then run the peervpn binary.
The following environment variables are supported. Note that some default values are of limited use.
| Variable | Default |
|---|---|
| NETWORKNAME | PEERVPN$RANDOM |
| PSK | PSK$RANDOM |
| INITPEERS | example.com 7000 |
| ENABLETUNNELING | yes |
| INTERFACE | peervpn0 |
| IFCONFIG4 | 172.16.254.$(expr $RANDOM % 256)/24 |
| IFCONFIG4 | fe80::1034:56ff:fe78:$(expr $RANDOM % 10000)/64 |
| LOCAL | 0.0.0.0 |
| PORT | 7000 |
| ENABLEIPV4 | yes |
| ENABLEIPV6 | yes |
| ENABLERELAY | no |
The example below will run a VPN between two containers. Both containers must configure different UDP ports (7001 and 7002) as they are on the same host. In the example below the IP address of the host running Docker is 10.0.2.15.
docker run --name=vpn1 -p 7001:7001/udp --cap-add=NET_ADMIN \
-e NETWORKNAME=mynet -e PSK=mykey -e PORT=7001 \
-e INITPEERS='10.0.2.15 7002' -e IFCONFIG4='172.16.1.1/24' -d \
thomasleister/peervpn
docker run --name=vpn2 -p 7002:7002/udp --cap-add=NET_ADMIN \
-e NETWORKNAME=mynet -e PSK=mykey -e PORT=7002 \
-e INITPEERS='10.0.2.15 7001' -e IFCONFIG4='172.16.1.2/24' -d \
thomasleister/peervpn
version: '3'
services:
peervpn:
image: thomasleister/peervpn
network_mode: "host"
cap_add:
- NET_ADMIN
restart: "always"
environment:
NETWORKNAME: srvnet
INTERFACE: "srvnet0"
PSK: thisisapresharedkey
LOCAL: "0.0.0.0"
PORT: 7000
INITPEERS: "1.2.3.4 7000"
IFCONFIG4: "10.8.0.1/24"
ENABLERELAY: "yes"
ENABLEIPV6: "no"
- Thomas Leister thomas.leister@mailbox.org (Fork)
- Markus Juenemann markus@juenemann.net (Original author)