Holybro UM982 GPS heading
VamsiTungala opened this issue · comments
Hello
I am trying to integrate UM982 with Pixhawk cube orange on X500 V2. I followed all the instructions as per the Pixhawk website but could not get the heading from UM982. Later I checked output of UM982 with UPrecise from which i observed was
GPS output:
$GNGGA,091510.00,5057.25505246,N,00653.73013267,E,5,24,0.6,48.3615,M,46.9156,M,1.0,0*54
$GNRMC,091510.00,A,5057.25505246,N,00653.73013267,E,0.004,47.0,090823,2.5,E,F,C*7A
#AGRICA,81,GPS,FINE,2274,292528000,0,0,18,27;GNSS,232,23,8,9,9,15,10,5,4,7,5,6,-0.9135,1.4475,-0.0400,0.0541,0.0978,0.1225,0.5867,-0.4194,0.0000,0.003,0.001,0.002,-0.002,0.051,0.040,0.065,50.95425087438,6.89550221116,48.3615,3996923.3714,483362.5189,4930414.1171,0.0550,0.0981,0.1250,0.1175,0.0941,0.0748,50.95425908545,6.89548161083,95.3171,0.00000000000,0.00000000000,0.0000,292528000,1.000,46.991943,46.915642,0.000000,0.000000,6,0,0,0*c64c9770
Last data command has heading data but autopilot device code does not have any parser to use that data.
So I had to change UM982 output to get it working.
is it supposed to be like that?
This issue has been mentioned on Discussion Forum for PX4, Pixhawk, QGroundControl, MAVSDK, MAVLink. There might be relevant details there: