Option in Source Meter Mode to not go over 3.3v (or be able to set any top value)
fostiras opened this issue · comments
The main reason I purchased PPKII was to be able to simulate different battery voltages on a low power project. If I am working on a 3.3Volt device (MCU) its very easy ,as I am adjusting voltages all the time, to go over 3.3 volts. It would make a nice safety feature for me to set the top voltage so the slider would not go over that voltage on it's far right position. Thank you for this great tool, it helped me A LOT.
Good feature request, thanks! I will add it to the backlog.
Thank you nicolai !!!
@fostiras this feature is now available in Power Profiler v3.3.0. For now it's only available under Advanced Options which is visible if you hit CTRL
+ ALT
+ SHIFT
+ A
. We do persist the value selected though, so it should be sufficient to just perform the action once (or whenever you want to update it). It is likely that we will make this more available in the near future.
Thank you Nicolai! If you ask me, this would be my preferred way too, being out of sight and under "the hood" .