Speeduino Compatible. Stm32F407
8 x injectors (high current)
8 x Ignition Output (selectable 5/12v) Coils with ignitors (Smart coils)
(Firmware will run sequential 8x8 ignition/Injection)
4 x High current (vvt , boost, idle 1, idle2)
1 x High current High side output (12 volt Positive, can drive V-Tech solenoid)
3 x low current, Fuel pump, Fan, Spare
(Total of 13 High Current outputs)
(Total of 3 Low current outputs)
Coolant
Intake air temp
TPS
MAP (internal + External) 250kpa or 400kpa internal available
O2 analog Input (Wideband and narrow)
4 x extra analog inputs 0-5v linear (Oil,Fuel pressure etc, Can be configured as temperature with bias resistor jumper)
(Total of 9 external Analog inputs)
Built in Dual VR Conditioner MAX9926 (selectable VR or HALL)
Baro Internal
Flex input
3 x Digital inputs (VSS etc)
Tach output (5v-12V Selectable)
Stepper idle (4 wire stepper) control plug in (Can be used for another 3 Medium current Outputs)
Winbond 26Q16 Flash memory. Faster read and writes(Less wear on MCU)
CAN Bus Communication (hardware, Up to Speeduino firmware if supported)
Quality robust USB B connector (not the crappy USB Mini connectors)
Aluminium cased
Uses Tuner Studio for tuning software
All come with both 26/34 pin connectors, Crimp pins, Wiring diagram and instructions.
All units are tested on a running engine before sending out. Please allow approximately 5-7 day lead time for unit to be built and tested. Every unit is hand assembled at the time of ordering. Takes me around 4 hours to assemble one unit without and accessories.
Currently Compatible with Speeduino firmware, You can read capabilities at http://www.speeduino.com
Please note these controllers are DIY EFI (Aftermarket and possibility not road legal). The user must have some degree of knowledge of how a engine works and Electronic Fuel Injection systems and Electrical wiring. As this is a DIY, I take no responsibility on how it is used and damage or harm it could cause. There is no warranty or responsibility implied in any way. I will help and support in any way possible and warranty against manufacturing defects. Physical damage, Vehicle associated or incorrect wiring will not be covered.