ESP32 Face Tracker Project

Overview

This repository hosts a project featuring an ESP32-CAM based human face tracker designed to dynamically adjust a laser pointer's position to follow a detected person. It uses the camera, the WiFi module, and the SD card reader of the ESP32-CAM. By default, this program does not enable WiFi and the SD card reader, but you can enable them in the menuconfig.

Configuration

Project-specific configuration can be found in main/Kconfig.projbuild and can be modified using the menuconfig tool.

idf.py menuconfig

Optimizing for Size

To optimize for size and ensure sufficient memory for enabling WiFi and the SD card reader, follow these steps:

Access the menuconfig tool:
```
idf.py menuconfig
```
Navigate to "Compiler options" -> "Optimization level" and select "Optimize for size".

WiFi

If you want to activate WiFi, set the password and SSID in the menuconfig under "Project configuration" -> "Laser configuration" -> "Use cam server". The ESP32-CAM will connect to the WiFi network and start a web server with an IP address provided by the router. You can view the IP address in the serial monitor. To access the web server, open a browser on a device connected to the same network and enter the IP address. The web server will display the last image taken by the camera at an interval of 3 seconds.

SD Card Reader

If you want to activate the SD card reader, set the option "Save detected faces in the SD card" to "y" in the menuconfig under "Project configuration" -> "Laser configuration". When the SD card reader is activated, the ESP32-CAM will save the last image taken by the camera on the SD card.

Flashing

To flash the project to the ESP32-CAM, follow these steps:

Recompile the project:
```
idf.py build
```
Connect the ESP32-CAM to the programmer and then to the computer.
Flash the project:
```
idf.py flash
```
To see the output of the program, execute:
```
idf.py monitor
```

This will display the serial monitor, where you can view the program's output.

Hardware Requirements

ESP32 CAM Programmer (used for flashing the ESP32) SG90 Servo Laser pointer (attached to the servo) Relay (used to turn the laser pointer on and off)

Schematic

Increase FLASH memory

idf.py menuconfig -> Component config -> ESP32-specific -> SPI Flash Size -> 16 MB

Enable PSRAM

idf.py menuconfig -> Component config -> ESP32-specific -> Support for external, SPI-connected RAM -> Support for external, SPI-connected RAM

Software Requirements

IDF 4.4 (Face detection will not work with IDF > 4.4)

if you have a newer version of IDF, you can downgrade to 4.4 by executing the following commands:

cd ~/esp/esp-idf
git checkout origin/release/v4.4
git submodule update --init --recursive

Setup Instructions

Connect the ESP32 CAM to the programmer. In the project directory, execute the following commands: idf.py set-target esp32 idf.py build idf.py flash Connect the ESP32 CAM to the following pins: Ground pin: GND 5V pin: 5V GPIO 12: Servo signal pin Relay pin: GPIO 13

Moh-Snoussi / esp32_laser_tracker