Design for a ergo split keyboard case
Load the file in openscad. Each side is made of four pieces. Comment out the bits you don't need at the bottom of the file. To get the right hand uncomment the 'mirror' line. The four pieces are top and bolts as one piece, bottom, caddy1 and caddy2. There are versions of the caddy for v3 and v4 of the elite-c.
- Access to a 3d printer. I printed this in PLA at 0.1mm layer height with supports.
- 2 x elite-c v4
- 2 x PJ340A TRRS jacks
- 14 x M3 8mm screws
- 14 x M3 nuts
- wire
Feel free to download or fork this. Please upload changes you make to your fork so the community can benefit. I'd appreciate a shoutout if you post a build on reddit.