Resize the size of swap memory on the Jetson Nano
Note that in addition to zram swap memory, you may want to also have a swapfile. See: https://github.com/JetsonHacksNano/installSwapfile/
Starting with L4T 32.2.1/JetPack 4.2.2, the Jetson Nano by default has 2GB of swap memory. The swap memory allows for "extra memory" when there is memory pressure on main (physical) memory by swapping portions of memory to disk. Because the Jetson Nano has a relatively small amount of memory (4GB) this can be very useful, especially when, say, compiling large projects.
The swap memory method in use is Zram. You can examine the swap memory information:
$ zramctl
You will notice that there are four entries (one for each CPU of the Jetson Nano) /dev/zram0 - /dev/zram3. Each entry has an allocated amount of swap memory associated with it, by default 494.6M, for a total of around 2GB. This is half the size of the main memory. You will find this to be adequate for most tasks.
However, there are times you may want to adjust the size of swap memory ...
The configuration for the Zram allocation is done on startup. The file that controls this is /etc/systemd/nvzramconfig.sh
The size of the Zram for each CPU is calculated by the line:
mem=$((("${totalmem}" / 2 / "${NRDEVICES}") * 1024))
where totalmem is the total amount of memory, and NRDEVICES is the number of CPUs.
Basically it divides the amount of physical memory by the number of CPUS with a divisor, in this case 2 to get the 2GB total. You can simply edit this equation using a text editor. You should probably make a backup of the file first, just in case. You will need sudo permissions to change the file.
sudo gedit /etc/systemd/nvzramconfig.sh
For example, you may remove the divisor to get a full 4GB.
You can also use the script in the repository.
usage: ./setSwapMemorySize [ [-g #gigabytes ] | [ -m #megabytes ] | [ -h ]
-g #gigabytes - #gigabytes total to use for swap area
-m #megabytes - #megabytes total to use for swap area
-h - help
Example usage:
$ ./setSwapMemorySize -g 4
will set the entire swap memory size to 4GB.
This will modify the /etc/systemd/nvzramconfig.sh to set the requested memory for the swap file as specified.
You will need to reboot for the change to take effect.
The recommended swap memory size is 2GB for a 4GB Jetson Nano. Larger swap memory sizes can sometimes cause decreased performance. It is recommended to use a swap file in addition to swap memory if you need larger amounts of memory for building projects.
November 2019
Initial Release
- v1.0
- Jetson Nano
- L4T 32.2.1/JetPack 4.2.2
- L4T 32.2.3/JetPack 4.2.2