Controleo3 Reflow Oven Controller
Reflow oven build guide:
http://www.whizoo.com/reflowoven
Buying Controleo3:
http://www.whizoo.com/buy
Updating the firmware running on Controleo3:
http://www.whizoo.com/update
This is the GitHub source code repository for Controleo3.
This software has been released under the CC BY-NC-SA 3.0 license. You are free To use it any way you wish.
In this folder are:
- README - this file
- Files that comprise the Controleo3 library for Arduino
- An "examples” folder containing the Reflow Wizard software
To install the Controleo3 library, please refer to:
http://arduino.cc/en/Guide/Libraries or http://www.whizoo.com/update
Reflow Wizard
- 1.0 Initial public release. (21 August 2017)
- 1.1 Bug fixes and features (9 September 2017)
- Fixed bug where servo movement would be erratic
- Fixed bug where running learning twice could cause the oven to overheat
- Added message when SD card wasn't FAT formatted
- Profile commands: added "beep" and ability to specify just how much the oven door should open
- 1.2 Tweaks for ovens with slow-response heating elements (1 November 2017)
- More responsiveness for all ovens, especially those with slow-response heating elements
- Minor oven scoring change to better reflect reality
- Number of reflows is now incremented as expected (Settings -> Stats)
- 1.3 Added new profile command "maintain" (15 November 2017)
- The oven can now hold a specific temperature for a certain duration
- See http://www.whizoo.com/profiles for more information
- 1.4 Minor improvement (18 December 2017)
- When switching between non-FAT and FAT16/FAT32 formatted cards, a reboot was needed. This has been fixed.
- Added comments and fixed spelling mistakes in the source code
Peter Easton 2017
whizoo.com