Jasrags / V2-1031-klipper_config

Pronter (V2.1031) Klipper Config

Klipper configs for this printer running fluidd.

Most the files in /configs are from eecue's klipper configs

Table of Contents

(!) = has important warning

• (!) Change Log
• Printer Mods
• Klipper Plugins

Change Log

Changes will be noted here by date, title if needed, files changed, summary of changes.

Note: only changes of signifigance will be added.

• 2021-11-08: The one where I try klicky probe again.
  • Enabled
    • configs/dockable_probe.cfg
    • configs/z_calibration.cfg
  • Disabled
    • configs/probe.cfg
  • configs/bed_mesh.cfg
    • Use dense bed mesh
      • probe_count: 5,5 -> probe_count: 9,9
      • relative_reference_index: 24 -> relative_reference_index: 77
  • configs/klipper_expander.cfg
    • Updated pin aliases
      • MOSFET0=PA0, MOSFET2=PA1, MOSFET3=PA2, MOSFET4=PA3, -> MOSFET0=PA0, MOSFET1=PA1, MOSFET2=PA2, MOSFET3=PA3
  • configs/main_printer.cfg
    • Updated pin aliases
      • LED-R=PB6, LED-G=PB5, LED-B=PB7, LED_NEOPIXEL=PD3, -> LED_R=PB6, LED_G=PB5, LED_B=PB7, LED_NEOPIXEL=PD3
  • configs/steppers.cfg
    • Slow down probing
      • homing_retract_dist: 3 -> homing_retract_dist: 2
      • second_homing_speed: 5 -> second_homing_speed: 2
  • macros/printing.cfg
    • Moved PRINT_START calibration commands to CALIBRATE in macros/calibration.cfg
  • macros/calibration.cfg
    • File created
      • Added CALIBRATE
        • Run printer calibration based on config. (quad_gantry_level,auto_z_offset,bed_mesh)
      • Added TEST_CALIBRATE
        • Command to test CALIBRATE macro
  • macros/uncategorized.cfg
    • Renamed SPEED_TEST to TEST_SPEED and added description
  • moonraker.conf
    • Added KlipperScreen to update_manager
  • flash_klipper.sh Added script to flash klipper on to all mcu instances.
• 2021-11-05: The one with square corners.
  • configs/main_printer.cfg
    • square_corner_velocity: 5.0 -> square_corner_velocity: 8.0
• 2021-11-04: The one where I try to improve probing accuracy.
  • configs/bed_mesh.cfg
    • relative_reference_index: 12 -> relative_reference_index: 24
  • configs/probe.cfg
    • y_offset: 25.0 -> y_offset: 23.0
    • samples: 3 -> samples: 4
  • macros/printing.cfg
    • PRINT_END
      • Modifed end position to be rear center
      • Added SONG_SINGLE_BEEP near the end

Printer Mods

• AB-BN-30- Improved afterburner hotend
• VEFACH - Voron Exhaust Filter Activated Coal + Hepa
• SexBolt - Alternative Z endstop
• Pins Mod
• GE5C Z Joint bearings
• Umbilical Strain Relief
• Afterburner Toolhead PCB
• Klipper Expander

Klipper Plugins

• frame_expansion_compensation
• gcode_shell_command