################################################################ # # Licensed to the Apache Software Foundation (ASF) under one # or more contributor license agreements. See the NOTICE file # distributed with this work for additional information # regarding copyright ownership. The ASF licenses this file # to you under the Apache License, Version 2.0 (the # "License"); you may not use this file except in compliance # with the License. You may obtain a copy of the License at # # http://www.apache.org/licenses/LICENSE-2.0 # # Unless required by applicable law or agreed to in writing, # software distributed under the License is distributed on an # "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY # KIND, either express or implied. See the License for the # specific language governing permissions and limitations # under the License. # ################################################################ NOTE: for instructions on how to get going with SVUnit, go to www.agilesoc.com/svunit. NOTE: Refer also to the FAQ at: www.agilesoc.com/svunit/svunit-FAQ ----------------------------------------------------------- Release Notes... ----------------------------------------------------------- See RELEASE.txt for release notes ----------------------------------------------------------- Step-by-step instructions to get a first unit test going... ----------------------------------------------------------- 1) setup the SVUNIT_INSTALL and PATH environment variables >export SVUNIT_INSTALL=`pwd` >export PATH=$PATH:$SVUNIT_INSTALL"/bin" 1a) or you can source the Setup.bsh (if you use the bash shell) >source Setup.bsh 1b) or you can source the Setup.csh (if you use the csh shell) >source Setup.csh 2) go somewhere outside SVUNIT_INSTALL (i.e. where you are right now) and start a class-under-test --- bogus.sv: class bogus; endclass --- 3) generate the unit test >create_unit_test.pl bogus.sv 4) add tests using the helper macros --- bogus_unit_test.sv: `SVUNIT_TESTS_BEGIN //=================================== // Unit test: test_mytest //=================================== `SVTEST(test_mytest) `SVTEST_END `SVUNIT_TESTS_END --- 5) run the unittests >runSVUnit -s <simulator> # simulator is ius, questa, modelsim, riviera or vcs 6) repeat steps 4 and 5 until done 7) pat self on back