FYSETC-VORON-2.4
1. Project
This is FYSETC's project database for VORON 2.4 kit, which is convenient for you to find information. Thanks for VORON Team's great work, they always design fantastic printers.
Official website:：https://vorondesign.com/voron2.4 Official Github：https://github.com/VoronDesign/Voron-2
In folder Voron-2-Voron2.4 beside this README file, we make some small changes base on the VORON official material. Like change the board to Spider and others.
2. BOM
Please check here.
3. Extra parts
Besides the parts in Voron sourcing guide, we offer extra useful parts for you.
Wire connector
This is for fans wire connection, with this connector you can wire two or more fans to one side of the connector, and the other side to Spider board. Then you can control the two or more fans with one control pin in Spider.
4. Printed parts:
You can find all printed parts in VORON website, VORON github.
Printed parts are not included in our VORON 2.4 kit, in some particular section of the machine, VORON provide you options. Like the plug panel at the back of VORON machine, you can choose plug_panel or plug_panel_filtered_mains. So in our kit, we also need to choose too, below is our choice.
plug panel: we choose this one.
Microswitch edge pod : this one.
Z Chain mount: our rev1.0 and rev1.1 Chain size is 1011 ,it is different from VORON sourcing size 1015, so we use our own printed part 1 and 2. On rev1.2 and later version, we changed to 1015, so you can use VORON printed parts. But the z chain mount you need to use this one.
Spider board mount: search 'Spider' here.
5. Wiring
5.1 Spider 1.x wiring
There is wiring from VORON community here. Also you can refer Spider wiring here.
Note: Check your fan voltage before you set the fan jumpers, the jumpers for fan in below diagram are all set to 24v.
5.2 Spider v2.2 wiring
If you use Spider v2.2, follow the wiring below
5.3 XY endstop
6. Firmware&OS
You can find example Klipper printer.cfg file on VORON github here or our Spider github here or gitee here. And you can get our pre-build firmware and OctoPi system image in the firmware&OS folder next to this README file.
6.1 OctoPi
We provide a SD card with OctoPi installed after rev1.1. You can login in Octoprint with the following account and password.
Account: FYSETC
Password: 12345678
Also we provide you Octopi OS system image for you, please check the README in firmware&OS folder.
OS SSH login account and password
Account: pi
Password: raspberry