Giters

Dviros / Klipper-Configs

Just my set of configs for the Artillery Genius Pro running Klipper

Geek Repo:Geek Repo

Github PK Tool:Github PK Tool

Klipper-Configs

Just my set of configs for the Artillery Genius Pro running Klipper.

Current Klipper Converstion Project Status:

  1. Artillery Genius Pro Stock - works very well
  2. Artillery Genius Pro SKR3 + LGX + EBB42 - works flawlessly

TODO:

  • LGX Over extrusion, basic calibration
  • Linear Rails on all axis
  • EBB42 1.2 on USB instead combined with the Genius EBB
  • EBB42 ADXL and Bltoutch
  • CANbus for the EBB, removing Artillery's shitty EBB and flimsy flat cable
  • Raspberry Pi mount inside the printer
  • LED mount on top

My setup:

  • LGX ACE Mosquito, CHT Nozzle, 24v Heating cartridge
  • Bigtreetech SKR3 EZ with EZ-TMC2209 drivers
  • Bigtreetech EBB42 1.0 running Klipper
  • PT1000\ATC Semitec 104NT-4-R025H42G thermistors
  • Linear Rails
  • ADXL345 input shaper (using EBB42)
  • Jetson Nano as the Moonraker\Octoprint\Mainsail server
  • Antclabs Bltouch 3.1

How to flash:

I've flashed Klipper using USB even though this specific chip does not support it and should be flashed using SD Card - it didn't work for me.

At the moment, bootloader is skipped and I can't revert to Marlin - be careful if you ever want to.

Set your config to the following:

image

and use dfu-util -a 0 -s 0x8000000:leave -D out/klipper.bin

What did you use to enhance your printer?

Here are the relevant projects I've used - all respect goes to them! Z Linear Rails:

X Linear Rails:

Rod support:

Brace support:

Belt tensioners:

Several considerations:

  1. Original Artillery mechanical endstops do not work with the SKR3; I had to revert to the generic 2-wired endstops
  2. Bltouch and Input Shaper settings needs to be defined in the printer.cfg for it to be modified by Mainsail
  3. LGX current needs to be around .650 RMS to avoid skippings

About

Just my set of configs for the Artillery Genius Pro running Klipper