Dlloydev

Dlloydev's repositories

QuickPID

A fast PID controller with multiple options. Various Integral anti-windup, Proportional, Derivative and timer control modes.

Language:C++MIT166 16 51

ESP32-ESP32S2-AnalogWrite

ESP32 PWM, Servo, Easing and Tone. Smart GPIO pin management and advanced control features.

Language:C++MIT91 4 24

Open loop PID autotuner using a novel s-curve inflection point test method. Tuning parameters are determined in about ½Tau on a first-order system with time delay. Full 5Tau testing and multiple serial output options are provided.

Language:C++MIT79 5 20

jtag2updi

HV UPDI / UPDI programmer software for Arduino (targets Tiny AVR-0/1/2, Mega AVR-0 and AVR-DA/DB MCUs)

Language:C++MIT26 3 19

Updi-Key

This DIY open source hardware connects inline with any UPDI programmer to provide a HV UPDI programming solution for tinyAVR® 0/1/2 series MCUs. Compatible with UPDI programmers that operate with jtag2updi, avrdude, pyupdi, MPLAB X IDE, MPLAB X IPE, PlatformIO and Arduino IDE using any target voltage from 3 to 5V.

Language:C++MIT14 1 3

Toggle

Arduino button debounce library for various switch types, port expanders and other 8-bit data sources. Fast and robust debounce algorithm.

Language:C++MIT9 1 5

Wokwi-Chip-Plotter

Debug Analog or Digital Signals

Language:CMIT2 10

Wokwi-Chip-Plot3

Plot Analog Signals

Language:CMIT1 20

Wokwi-Chip-PWM

PWM Signal Generator

Language:CMIT1 10

Wokwi-Chip-Scope

This 4 channel scope chip allows you to monitor four analog or digital signals as they vary over time.

Language:CMIT1 1 2

Wokwi-Chip-1-of-8-Decoder

This chip provides eight mutually exclusive outputs. The Select range control enables and sets the active-high output.

Language:CMIT010

Wokwi-Chip-Analog-Bargraph

Converts an Analog Signal to 10-bit Bargraph or Binary

Language:CMIT010

Wokwi-Chip-Bounce

Bounce Signal Generator

Language:CMIT010

Wokwi-Chip-Debounce

Debounce and Deglitch a digital signal

Language:CMIT010

Wokwi-Chip-Digital-Plot3

Plot Digital Signals

Language:CMIT010

Wokwi-Chip-Mux-8-to-1-Analog

This chip connects 1 of 8 analog inputs to a single output. When Select = 0 (default), the output is 0. An LED PWM output is available for diagnostic use.

Language:CMIT010

Wokwi-Chip-Mux-8-to-1-Digital

This chip connects 1 of 8 digital inputs to a single output. When Select = 0 (default), the output is disabled (0).

Language:CMIT010

Wokwi-Chip-Toggle

Provides Toggle Outputs for a Pushbutton

Language:CMIT010