BlackMix / pimox7

Proxmox V7 for Raspberry Pi

Pimox - Proxmox V7 for the Raspberry Pi

Pimox is a port of Proxmox to the Raspberry Pi allowing you to build a Proxmox cluster of Rapberry Pi's or even a hybrid cluster of Pis and x86 hardware.

Requirements

• Raspberry Pi 4
• Pre-installed Debian Bullseye based 64-bit OS (not 32bit)

Prechecks

1. In /etc/network/interfaces, give the Pi a static IP address. You cannot use dhcp.
2. In /etc/network/interfaces, remove any IPv6 addresses.
3. In /etc/hostname, make sure the Pi has a name.
4. In /etc/hosts, make sure this hostname corresponds to the static IP you previous set.

Install

1. Do this at the console, not over a network. The network will be reconfigured as part of the install.
2. sudo -s
3. curl https://raw.githubusercontent.com/pimox/pimox7/master/pimox.sh | sh

RPiOS64 autoinstall

0. Flash and startup the latest image from https://downloads.raspberrypi.org/raspios_arm64/ .
1. sudo -s
2. curl https://raw.githubusercontent.com/pimox/pimox7/master/RPiOS64autoinstall.sh > RPiOS64autoinstall.sh
3. nano RPiOS64autoinstall.sh
4. Adjust network and hostname settings.
5. chmod +x RPiOS64autoinstall.sh
6. ./RPiOS64autoinstall.sh
7. Type a new root password.
8. Retype new password.
9. Do not touch it untill, reboot is done.

Notes

1. This repo just contains the precompiled debian packages. The original Proxmox sources can be found at https://git.proxmox.com
2. The (very minimally) patched sources to rebuild this can be found at https://github.com/pimox