Ataberk ÖKLÜ's repositories
Linear-MPC-Lanekeeping-ObstacleAvoidance
Linear MPC for Lane Keeping and Obstacle Avoidance on Low Curvature Roads - Paper Application
STM32-FlySky-IBus
Telemetry application over RF (2.4 GHz) using FlySky Fs-i6x and STM32 Microcontroller
STM32-USB-HID
Mouse / Keyboard / TouchScreen USB HID Projects
KeySim
ARM Cortex based STM32 MCU Project. The main purpose of the project is to allow the user assign Mouse and Keyboard Events to the Buttons' or IO Expanders' Trigger Events connected to the MCU. The MCU can be programmed by using KeySim-API program over UART. Moreover, The MCU acts as USB HID Device to send Keyboard and Mouse Reports to PC or CPU.
STM32L476-BootLoader
The purpose of this project is to bypass the physical requirements of the BootLoader access. The approach is the trigger the MCU to enter BootLoader Mode via UART by only using Tx, Rx and Gnd pins. Moreover, the trigger UART port can also be used to program the MCU.
Audio-Frequency-Based-Stepper-Motor-Driver-on-ARM
Audio Frequency Based Stepper Motor Driver on ARM (Assembly) with CMSIS DSP Implementation
ModelUydu-STM32-Altium
ModelUydu-STM32-Altium
SaleTerminal
FPGA Based Point of Sale Project using Verilog
STMF746_TCP_BootLoader
In-Application Programming Implementation using TCP IP Protocol
A_Visible_Light_Communication_System
A Visible Light Communication System
ARM-Architecture
ARM based Low Power MicroController Implementation on FPGA platforms using Verilog
binbloom
Raw binary firmware analysis software
KeySim-API
The API for the KeySim Project. This API is to program the MCU to perform each keys assigned actions via UART. The MCU is acting re-programmable USB HID device. The Main Project is below.
Noise_Level_Indicator_Analog_Circuit
Noise Level Detector - Analog Circuit