STM32 SD library for Arduino

With an STM32 board with SD card slot availability, this library enables reading and writing on SD card using SD card slot of a STM32 board (NUCLEO, DISCOVERY, ...).

This library follow Arduino API.

For more information about it, please visit: http://www.arduino.cc/en/Reference/SD

Dependency

This library is based on FatFs, a generic FAT file system module for small embedded systems.
http://elm-chan.org/fsw/ff

The FatFs has been ported as Arduino library here. The STM32SD library depends on it.

Configuration

FatFs

The FatFs has several user defined options, which is specified from within the ffconf.h file.

This library provides a default user defined options file named ffconf_default.h.

User can provide his own defined options by adding his configuration in a file named ffconf_custom.h at sketch level or in variant folder.

SD

Some default definitions can be overridden using:

board variant.h
build_opt.h: see Customize build options
hal_conf_extra.h: see HAL configuration

SD configurations

SD_INSTANCE: some STM32 can have 2 SD peripherals SDMMC1 and SDMMC2, note that this library can managed only one peripheral
- SDMMC1 (default)
- SDMMC2
SD_HW_FLOW_CTRL: specifies whether the SDMMC hardware flow control is enabled or disabled
- SD_HW_FLOW_CTRL_ENABLE
- SD_HW_FLOW_CTRL_DISABLE (default)
SD_BUS_WIDE: specifies the SDMMC bus width
- SD_BUS_WIDE_1B
- SD_BUS_WIDE_4B (default)
- SD_BUS_WIDE_8B

SD Transceiver

SD_TRANSCEIVER_MODE: specifies whether external Transceiver is enabled or disabled. Available only on some STM32
- SDMMC_TRANSCEIVER_ENABLE
- SDMMC_TRANSCEIVER_DISABLE (default)
SD_TRANSCEIVER_EN pin number to enable the level shifter
SD_TRANSCEIVER_SEL pin number for voltage selection

SD detect and timeout

SD_DETECT_PIN pin number
SD_DATATIMEOUT constant for Read/Write block

AnHardt / STM32SD