- Built-in palm rest - the palm rest should follow whatever tent or tilt you use, providing constant support as your keyboard shifts around.
- Modular - the base and the stand are separated, and easily assembled to allow easier adjustments to tenting angle.
- Low volume - designed to use less material and save cost. Not everyone owns a 3D printer.
- Open
lily58.FCStd
with FreeCad. - Edit the models to get the recommended measurements:
- Set the wall height at
base > belt002 > belt001
. SetLength Fwd
with this formula:3mm + standoff height + top plate height + 0.25mm
. This should allow the wall to reach the bottom of the keycaps. - Set the palm rest height at
base > palm > palm001
. SetLength Fwd
to something near the wall height. Ideally it should be slightly lower than your keycaps. Subtract some height if you are adding some foam. - (Optional) Adjust the length of the palm rest at
base > palrm > palm001 > Rectangle002
by setting they
position. I am 183cm. You might want to add or reduce a few mm. Ideally the bottom of the palm rest will touch the ball of your palm without touching your wrist.
- Set the wall height at
- Export the parts:
stand
,base
, andlock
.