This guide aims to outline how to create and set up the PIR system as outlined in Brown et al 2016
It will provide an overview of the requirements, basic building, setup, and some basic troubleshooting. For further help, contact the authors.
- Build PIRs
- Setup PIRs
- Troubleshoot PIRs
For specific details, see Brown et al 2016.
- Sensor circuit Boards - Fritz file available in paper supplementary file 3.
- Resistors
- 1k, 10k
- PIR sensors
- horizontal telephone connectors
- 2 pin connectors
- LDRS
- Solder all together!
- Cables <- cut to required length
- telephone cable connectors, 4 inner wires.
- Arduino Uno
- circuit board
- Fritz design present in paper supplement file 4.
- Vertical connectors
- 2, 1, 6 pin connectors
- USB to ? usb cable
- Rasbperry Pi
- Power source
- SD card
- Arduino IDE
- NOOBS
- node-red - installed by default with NOOBS
Fisk, A.S. angus.fisk@ndcn.ox.ac.uk
McKillop L.
Krone L.
van der Vinne V.
Based on Brown et al 2016.