Foldable RepRap printer. Not ready for production, but almost done.
To rebuild the parts, run make (you'll need openscad in $PATH).
It is advised to run make calibration first, print the result and adjust configuration.scad until you are satisfated.
- Once:
- x-carriage.stl
- x-end-idler.stl
- x-end-motor.stl
- ybrac-t.stl
- Twice:
- belt-clamp-nut-holder.stl
- cornerL.stl
- cornerR.stl
- coupling.stl
- motortop.stl
- topholder.stl
- side.stl
- Four times:
- belt-clamp.stl
And if you don't use alluminium pulleys, print also pulley8.stl twice.
This printer is licensed under the terms of GNU GPL version 3, see COPYING.
Lot's of parts are form josefprusa/PrusaMendel - some of them are bit modified.