Sonic_Pad_Firmware

Sonic Pad Fimrware for Factory Reset "Burn Mode".

!! WARNING !! !FLASH AT YOUR OWN RISK.!

Flashing your Sonic Pad to Factory Build is at YOUR OWN RISK, i only supply this Firmware and a guide to Reflash. I Can´t be held responsible for any errors during this Reset. Please be adviced to only make this Reflash if your Sonic Pad is not responding at all or it is bricked.

This Firmware is overwriting everyting on the Sonic Pad, and should only be used if there is no other alternative to making the Sonic Pad work as intended.

Please follow the INSTRUCTIONS !.

!! Before you begin, make sure you have an USB-A to USB-A cable otherwise the burn tool wont detect the Sonic Pad. !! ( IMPORTANT ) You need to go to device manager when you have powered up the Sonic Pad while its connected to your PC. ( You will not get any notification when its connected, it will only show in Device manager. In the Device manager you will have an "Unknown" USB/device, update the Driver on this USB/device with the USB Driver located in the Phoenix Suite Folder ( Drivers ). You need to restart your PC to make sure its properly installed. When this is Done you are now ready to follow the steps below.

1. Download Phoenix Suite for Windows.

2. Unzip the Phoenix Suite Burn Tool.

3. Download the Sonic Pad Firmware from this GitHub repository.

4. Unzip the Sonic Pad Firmware to a folder of your own choice.

5. Start the Phoenix Suite program ( Phoenix Suite.exe ).

6. Connect the USB-A cable to the Sonic Pad ( has to be in the USB-A CAM Port ), make sure the Sonic Pad is turned OFF.

7. Connect the other end of the USB-A cable to any USB-A port on your computer.

8. Now insert a pointy obejct in the ( FEL ) hole on the back of the Sonic Pad, it is the hole furthest to the right.

9. While holding the ( FEL ) button in, you turn on the Sonic Pad.

10. When the Sonic Pad has turned on, a green light will show in the end of the Sonic Pad.

11. The Sonic Pad is now in Burn Mode.

12. In Phoenix Suite you should now choose Firmware and then choose the Image ( Image Button ).

13. When you have located the Firmware and the Soni Pad shows as Connected in the buttom, then you are Ready to push Upgrade.

14. The Sonic Pad will now install the firmware ( it takes about 5-15 min depending on your system ).

When all this is Done you can now update the Sonic Pad with the newest Firmare in the Sonic Pad´s menu.

NOTE !! This has been tested and it WORKS 100%. If you encounter any issues, then let me know by sending me an @mail: github@3dprintspotlight.com

Troubleshooting. If your Sonic Pad is not shown as Connected at the buttom of Phoenix Suite, then try to restart your Sonic Pad and Pheonix Suite. And then go to Step ( # 8 ).

The Sonic Pad Manual can be found on Creality´s Website in the Support Download Center.

3D-Print-Spotlight / Sonic_Pad_Firmware