Giters

wyolum / mmM

mmMercury is an Open Hardware, blood pressure measurement device (not FDA approved).

Geek Repo:Geek Repo

Github PK Tool:Github PK Tool

Need enclosure design

osbock opened this issue · comments

commented

I started working on a case design for mmM.

Got the base done. See attached image. Next up is the top cover with
various cutouts.
I've checked it in to the repo. Freecad file under the Fabricate directory.

Best Regards,

Anool Mahidharia
Work http://www.lumetron.com/
DiY http://www.wyolum.com/
Hackaday http://hackaday.com/about/
HackerSpace http://www.makersasylum.com
Git https://github.com/anool
Cycling http://cyclists.in/profile/AnoolJM
Workouts http://www.dailymile.com/people/anool
Flickr http://www.flickr.com/photos/anool
Picasa http://picasaweb.google.com/anool.m

On Tue, Feb 16, 2016 at 4:11 AM, Kevin Osborn notifications@github.com
wrote:

—
Reply to this email directly or view it on GitHub
#3.

commented

Excellent!
Make sure there is room under the pump mount for socket head cap screw
heads.
Planning to get the right length screws and use m3 locknuts on top.

On Wed, Feb 17, 2016 at 1:30 PM, Anool Mahidharia notifications@github.com
wrote:

I started working on a case design for mmM.

Got the base done. See attached image. Next up is the top cover with
various cutouts.
I've checked it in to the repo. Freecad file under the Fabricate directory.

Best Regards,

Anool Mahidharia
Work http://www.lumetron.com/
DiY http://www.wyolum.com/
Hackaday http://hackaday.com/about/
HackerSpace http://www.makersasylum.com
Git https://github.com/anool
Cycling http://cyclists.in/profile/AnoolJM
Workouts http://www.dailymile.com/people/anool
Flickr http://www.flickr.com/photos/anool
Picasa http://picasaweb.google.com/anool.m

On Tue, Feb 16, 2016 at 4:11 AM, Kevin Osborn notifications@github.com
wrote:

—
Reply to this email directly or view it on GitHub
#3.

—
Reply to this email directly or view it on GitHub
#3 (comment).

commented

Also, mine came with a straight header for FTDI. it would probably be better if it stuck out the side. I'll desolder and put in a right angle.

commented

Another point: the pump end of the case needs a little clearance for tubing, as the barbs for the pressure sensor and the pump come right to the board edge.