Host name is not stored

[Google Code Exporter]

What steps will reproduce the problem?
1. Reboot due to power failure (haven't tried others)
2. Try to access shares via defined host name
3.

What is the expected output? What do you see instead?
I try to access the NAS from a windows system via \\<<<defined host name in 
Setup->Host>>> but the default is reset after reboot, i.e. in my case 
\\dlink-xxxx

What Alt-F version are you using? Have you flashed it?
Alt-F 0.1RC2, not flashed

What is the box hardware revision level? A1, B1 or C1? (look at the label
at the box bottom)
A1

What is your disk configuration? Standard, RAID (what level)...
Raid 1

What operating system are you using on your computer? Using what browser?
Win 7 / Opera

Please provide any additional information below.

Original issue reported on code.google.com by [e-mail] on 10 Jan 2013 at 10:29

[Google Code Exporter]

-What is the name displayed in the "Host Setup" page after the reboot?
-Are you using a fixed IP or DHCP in the D-Link setup?
-Was you able to "save settings"?

In "reloaded" mode, there is one known issue regarding samba, read the RC2 
announcement followup posts.

Original comment by [e-mail] on 14 Jan 2013 at 4:52

[Google Code Exporter]

Closing for lack of user feedback.

Original comment by [e-mail] on 16 Mar 2013 at 6:07

• Changed state: WontFix

[Google Code Exporter]

[deleted comment]

[Google Code Exporter]

[deleted comment]

[Google Code Exporter]

Sorry, completely forgot to reply:

-What is the name displayed in the "Host Setup" page after the reboot?
--> Actually I currently would not like to reboot, but it is the default name 
that was used also after the first usage

-Are you using a fixed IP or DHCP in the D-Link setup?
--> fixed IP

-Was you able to "save settings"?
--> Yes, settings were saved

Original comment by [e-mail] on 16 Mar 2013 at 8:38

[Google Code Exporter]

When using the "reloaded" mode, the host name and its IP is inherited from the 
D-Link environment (if the fun_plug file is not modified and its KIP line is 
not commented).

Thus the host name should be the same as it is set under the D-Link firmware, 
it does not matters if you change it under Alt-F and save settings.

Trying to access the box using its name and not its IP is dependent on your 
network setup (DHCP server and/or nameserver), so I can't comment on that.

Anyway RC3 is currently being tested and close to be released, so reopen this 
issue if needed.

Thanks

Original comment by [e-mail] on 17 Mar 2013 at 6:00