Driver Fails to be installed on nv_nano

[Giray Yillikci]

Hello Vasily,

Thanks for the repo firstly,

I am struggling to make the driver work on jetson nano.I modiefed the Makefile as:

CONFIG_PLATFORM_I386_PC = n . . . CONFIG_PLATFORM_ARM_NV_NANO = y
and installed it by sudo make install.

when I plug the AC56 and dmesg, i see that the driver is already registered seen below:
6.314813] iwlwifi 0000:01:00.0: Falling back to user helper [ 6.328989] usbcore: registered new interface driver rtl8812au [ 6.399248] 8812au: loading out-of-tree module taints kernel. [ 6.467905] RTL871X: module init start [ 6.467910] RTL871X: rtl8812au v4.3.8_12175.20140902 [ 6.467913] RTL871X: build time: Jun 20 2021 16:20:41 [ 6.467931] Error: Driver 'rtl8812au' is already registered, aborting... [ 6.474810] RTL871X: module init ret=-16 [ 6.806752] usbcore: registered new interface driver rtl88XXau [ 6.819857] iwlwifi 0000:01:00.0: Direct firmware load for iwlwifi-8265-24.uc

On jetson, there are two kernels:
4.15.0-144-generic 4.9.201-tegra

My problem is when I run sudo iw dev wlan0 set type monitor I get command failed: Operation not supported (-95)
I am not sure how the driver mechanism works but, couldnt find out the cause. Can you help on this issue?

Best,

Giray

[Vasily Evseenko]

rtl8812au v4.3.8_12175.20140902

It seems that old driver already loaded. Try to do find /lib/modules -name 8812 or find /lib/modules -iname 88XX, remove them and rebuild initramfs