FM24C04B problem
rozrabiak opened this issue · comments
Hi, I have connected FM24C04B.
i2c scanner shows me this addresses:
01:07:29.324 -> I2C device found at address 0x50
01:07:29.324 -> I2C device found at address 0x51
but I have only one chip connected to Arduino.
Which address should I use?
Library in debug mode shows me:
01:10:14.034 > FRAM
01:10:14.055 > FRAM_MB85RC_I2C object created
01:10:14.055 > I2C device address 0x50
01:10:14.055 > WP pin number 13
01:10:14.055 > Write protect management: true
01:10:14.055 > Memory Chip NOT FOUND
01:10:14.055 > ...... ...... ......
Thank's for help, reply, etc.
Hi,
Can you check the address ?
Have a look on datasheet to check this out
Above addresses I got when A1 and A2 pulled-down.
When A1 and A2 are pull-down I have two addresses: 0x7... I don't remember now :-(
In my IC I have two pi for address settings, A1 and A2.
The address is then 0b101000 following by the page bit. This makes a 7bit address which would work (8th bit is reserved for R/W operation).
This makes 0x50 or 0x51 depending on the page you want to access.
The library has been built with mb85rc256v. Compare with that datasheet to be sure. Your device has been reported working by users
Memory Chip NOT FOUND
same problem
resultr = mymemory.getOneDeviceID(1, &id);
Serial.print("Manufacturer 0x");
Serial.println(id, HEX);
resultr = mymemory.getOneDeviceID(3, &id);
Serial.print("DensityCode 0x");
Serial.println(id, HEX);
resultr = mymemory.getOneDeviceID(4, &id);
Serial.print("Density ");
Serial.println(id, DEC);
returns
Manufacturer 0xFFF
DensityCode 0xF
Density 0
.....1st test
Writing at location 0x25
Writing...
Calculated address 0x50
Reading...
Calculated address 0x50
[WiFi-event] event: 4
[WiFi-event] event: 7
WiFi connected. IP address: 10.99.99.163
Connecting to MQTT... in loop
[ 2632][E][Wire.cpp:392] requestFrom(): i2cRead returned Error 263
Written value 0xBE
Read value 0xFF
Write Byte test : NOT OK
.... ....
2nd test
Writing at location 0x7B0
Writing...
Calculated address 0x50
Reading...
Calculated address 0x57
[ 3643][E][Wire.cpp:392] requestFrom(): i2cRead returned Error 263
Written value 0xBEEF
Read value 0xFFFF
Write word test : NOT OK
.... ....
esp32, i have working bmp180 and pcf8574ts on wire
tried wire running at 100000 and 400000
i2c scan detects 0x50 if Vdd = 5V, but not works.
i used 10k pullup resistors near ic