sinedied / pi-midi-host

Setup a Raspberry Pi as a headless MIDI USB host

🎶 pi-midi-host

Setup a Raspberry Pi as a headless MIDI USB host, with auto-connection and MIDI merging of all sources.

Tested with a RPi 3B and Zero 2W, but should work with any model. MIDI Bluetooth will only work on model 3/4 and Zero 2W as earlier models don't have an onboard bluetooth chip (though it might be possible to used an external BT dongle).

Usage

1. Download latest Raspberry Pi OS lite image and install it on your SD card with Raspberry Pi Imager
2. Create a new file named ssh in /boot folder of the SD card to enable SSH access.
3. SSH to your RPi with ssh pi@<IP_ADDRESS> (default password is raspberry)
4. Run this command: bash <(curl -Ls https://raw.githubusercontent.com/sinedied/pi-midi-host/main/setup.sh)
5. Reboot

Note: the filesystem is switched to read-only at the end of the setup, to avoid SD card corruption when powering off. To switch it back on and off, use the rw and ro commands.

Aliases

Use these alias to quickly manage your midi setup:

• midi: show connected midi devices
• connect: reconnect all midi devices

How to connect bluetooth devices

1. Disable SSP mode (if needed): sudo hciconfig hci0 sspmode 0
2. Turn on your bluetooth device and put it in pairing mode
3. Run sudo bluetoothctl -a
4. default-agent
5. pair <BT_ADDRESS>
6. trust <BT_ADDRESS> to allow auto reconnection
7. connect <BT_ADDRESS> if connection did not work
8. exit

Network access

You can SSH to the device without knowing its IP address using ssh [e-mail] after initial setup.

Credits

Most of this work was based on instructions from this post.

Additions:

• All-in-one script to setup a new Pi
• MIDI in/out filters for specific devices
• Bluetooth device connection instructions
• Commands aliases
• Drivers for M-Audio MIDISPORT 2x2