Reatlek 8821CU Cannot put device in monitor mode
MONO77 opened this issue · comments
Hi, I am trying to make OWL work on my USB Wifi Adapter which is based on chip Reatlek 8821CU. I have already installed driver on it, with "CONFIG_WIFI_MONITOR" option on.
However, when I am trying to activate OWL with command sudo owl -i wlan1
where wlan1 is the corresponding interface, I get the error of
ERROR: Error while receiving via netlink: Operation not supported
ERROR: Could not put device in monitor mode: wlan1
ERROR: could not initialize core
even though I have turned on the monitor mode by using iw. Here is the output of sudo iw dev
which shows that I have monitor mode turned on:
phy#6
Interface wlan1
ifindex 12
wdev 0x600000001
addr 20:0d:b0:4f:33:77
type monitor
txpower 12.00 dBm
phy#0
Unnamed/non-netdev interface
wdev 0x3
addr 34:2e:b7:17:4d:00
type P2P-device
txpower 0.00 dBm
Interface wlan0
ifindex 5
wdev 0x2
addr 34:2e:b7:17:4d:ff
ssid WIFI-CZ
type managed
channel 1 (2412 MHz), width: 20 MHz, center1: 2412 MHz
txpower 22.00 dBm
multicast TXQ:
qsz-byt qsz-pkt flows drops marks overlmt hashcol tx-bytes tx-packets
0 0 0 0 0 0 0 0 0
I am not quite sure what happened to make this not working. Any help is appreciated, thanks.
Please read #9 (comment)
Hi, I do not think that my problem belongs to the situation described in #9. As you can see in my description, the card I am using is actually capable of active monitoring mode.
If that is not clear enough, here is the relevant content of using iw phy phy1 info
:
Supported interface modes:
* IBSS
* managed
* AP
* monitor
* P2P-client
* P2P-GO
I appologize if I am misinterpreting anything.
There is no mention of active monitor mode in the output.
Hi, sorry, my bad.