error: programmer did not respond to command: set addr
mahuti opened this issue · comments
Chris Newton commented
When running the updater on Raspberry Pi 3, I get the following error.
Reading | ########### | 21% 0.10savrdude: error: programmer did not respond to command: set addr 2018/02/26 19:11:45 exit status 1
However, when I check the firmware number it originally stated 1.1, and now says 1.2. So the update happened, but it looks like the system could not confirm that it worked successfully.
In my quick testing, I'm now able to use an atari controller (and was not able to do so before) so it looks to have worked except for the confirmation.
Connecting to programmer: .
Found programmer: Id = "LUFACDC"; type = S
Software Version = 1.0; No Hardware Version given.
Programmer supports auto addr increment.
Programmer supports buffered memory access with buffersize=128 bytes.
Programmer supports the following devices:
Device code: 0x44
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e958a
avrdude: reading input file "firmware.hex"
avrdude: input file firmware.hex auto detected as Intel Hex
avrdude: writing flash (17356 bytes):
Writing | ################################################## | 100% 1.73s
avrdude: 17356 bytes of flash written
avrdude: verifying flash memory against firmware.hex:
avrdude: load data flash data from input file firmware.hex:
avrdude: input file firmware.hex auto detected as Intel Hex
avrdude: input file firmware.hex contains 17356 bytes
avrdude: reading on-chip flash data:
Reading | ########### | 21% 0.10savrdude: error: programmer did not respond to command: set addr
2018/02/26 19:11:45 exit status 1
Florian commented
Strange. The download to the GamepadBlock worked fine, the read back process was interrupted for some reasons.
Did you run this on Windows, Linux, OSX?
Chris Newton commented
I ran it on a Raspberry Pi 3
…On Wed, Feb 28, 2018 at 12:50 PM Florian ***@***.***> wrote:
Strange. The download to the GamepadBlock worked fine, the read back
process was interrupted for some reasons.
Did you run this on Windows, Linux, OSX?
—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub
<#1 (comment)>,
or mute the thread
<https://github.com/notifications/unsubscribe-auth/AAy5XRDNyPkVoNmqpMd3I6soPjfhuWupks5tZZ_BgaJpZM4SUNNY>
.
Chris Newton commented
To be clear I ran it on RetroPie. So Raspbian Linux.